The belt sweeper is poorly cleaned, and the cleaning device installed in some areas causes many safety accidents. The site often finds a cleaning point to install 7-8 sweepers, but the actual cleaning effect is poor. In some areas, the belt joint is cracked after installing the cleaner. The overall belt tear problem, the production of these problems is caused by the following factors:

1, the cleaning device selection error

2, the cleaning device installation position is wrong

3, the cleaning cutter head is not wearable

The so-called selection error is mainly due to the specific selection of the cleaner according to the specific mining conditions, such as the use of mechanical joints on the conveyor belt can not install the alloy cleaner; the herringbone belt must use the drum cleaner, polyurethane cutter head Only suitable

One-way belt cleaning and other problems, the second-stage cleaner using a polyurethane cleaner can not meet the cleaning effect.

The sweeper manufacturer should provide the necessary technical support, such as scientific and effective analysis based on the on-site industrial and mining conditions provided by the customer, accurate selection of the cleaner, and provision of a practical cleaning device installation and fixing method. Problem solution.